Installing a splash guard or mud guard set is the best way to prevent unsightly paint chips and the onset of corrosion on your car's lower body panels. Keeping your Mazda CX-9's paint pristine helps keep that premium Mazda look and protects your vehicle's long-term resale value.

Basic Steps to Install Your New Splash Guards

Replacing or adding mud guards in your Mazda is straightforward with the correct tools and procedure. Do the following:

1. Clean the Wheel Well

Wash the installation area thoroughly to remove any trapped grit.

2. Turn the Steering Wheel

For front installation, turn the wheels all the way to the side to provide more room for your screwdriver or wrench.

3. Remove Factory Fasteners

Remove existing screws or plastic clips from the fender liner that will be used to secure the guard.

4. Position the Guard

Hold the splash guard against the body, ensuring the pre-drilled holes in the guard line up with the factory locations.

5. Hand-Tighten the Hardware

Start each screw by hand to ensure they aren't cross-threading, then tighten them until the guard is snug against the body. For more exterior protection, check out other exterior accessories that enhance your CX-9’s look.

6. Verify the Seal

Ensure there are no gaps between the guard and the paint. A tight seal prevents sand from scuffing the finish.

Protect your investment with accessories that are engineered for a perfect, factory fit. For help selecting the right set for your Mazda, contact us at Mazda Wholesale Direct today.

Filter

My Garage